Sony Vaio Pcga2sylpe User Manual

Care and Handling of Your VAIO® Computer  
Proper Handling  
Use your computer on a clean dry, stable surface.  
Use only specified peripheral equipment and interface cables or you may experience problems.  
When your computer is brought directly from a cold location to a warm one, moisture may condense  
inside the computer. If this occurs, wait at least one hour before turning on the computer. If you  
experience problems:  
§
§
§
Unplug the computer  
Remove the battery pack  
Contact eSupport at 1-888-476-6972  
IMPORTANT  
Proper air circulation is important to prevent overheating. Do not block your  
computer’s air vents, located on the bottom of your notebook computer, by  
placing the computer on porous surfaces. For example, materials such as  
rugs, blankets, couches, beds or curtains, can block the computer’s air vents.  
IMPORTANT  
Do not place your computer directly on your lap. The temperature of the bottom  
of the unit rises during normal operation. The heat can cause discomfort.  
1 of 5  
Using the Battery Pack  
Use original Sony battery packs. Sony cannot guarantee product safety when third party non-original  
replacement battery packs are used. We recommend purchasing the battery packs directly from official  
Sony resellers to avoid counterfeit products.  
§
§
§
§
Do not leave battery packs in temperatures above 140°F (60°C), such as in a car parked in the  
sun or under direct sunlight.  
Battery life is shortened in a cold environment. This is due to decreased battery efficiency at low  
temperatures.  
Charge battery packs at temperatures between 50°F (10°C) to 86°F (30°C). Lower temperatures  
require longer charging time.  
Certain rechargeable battery packs do not meet Sony quality and safety standards. For safety  
reasons this computer should only be connected to genuine Sony battery packs designed for this  
model. If an unauthorized battery pack is installed the results could be unpredictable.  
§
While the battery pack is in use or being charged, heat builds up in the battery pack. This is  
normal and is not cause for concern.  
§
§
§
§
§
Keep the battery pack away from all sources of heat.  
Keep the battery pack dry.  
Do not open or try to disassemble the battery pack.  
Do not expose the battery pack to any mechanical shock, such as dropping it on a hard surface.  
If you are not using your computer for a long period of time, remove the battery pack from the  
computer to prevent damage to the battery pack.  
§
If you have not used the battery pack for a considerable amount of time, the remaining battery life  
may become short. However, this is normal and does not indicate a malfunction, because the  
battery pack will gradually discharge over time even when not in use. Connect the AC adapter to  
your computer and recharge the battery pack before using the computer again.  
§
§
There is no requirement to discharge the battery pack before recharging.  
If the battery pack quickly runs out of power after being fully charged, it may have reached the  
end of its life and should be replaced.  
Using the AC adaptor  
Make sure that the power cable is properly connected to the AC adapter; only use the power cable that  
was delivered with the VAIO PC and/or AC adaptor.  
If the AC adaptor was delivered with a 3 pin power cable, use the AC adaptor with a properly grounded  
wall socket to avoid a small static charge building up on the notebook casing.  
During operation the AC adaptor might get warm, make sure the AC adaptor is in a well ventilated area  
with the label facing down.  
IMPORTANT  
Use only Sony original AC adaptors. Sony cannot guarantee product safety  
when non-original AC adaptors are used. You can purchase AC Adaptors  
directly from official Sony resellers to avoid counterfeit products.  
3 of 5  
Handling the CD / DVD / Blu-ray Disc™ media  
Do not touch the surface of the disc.  
Fingerprints and dust on the surface of a disc may cause read errors. Always hold the disc by its edges  
and central hole, as shown below:  
Proper care of the disc is essential to its continuous reliability. Do not use solvents (such as benzine,  
thinner, alcohol, commercially available cleaners, or anti-static spray) which may cause damage to the  
disc.  
For normal cleaning, hold the disc by its edges and use a soft cloth to wipe the surface from the center  
out.  
If the disc is badly soiled, moisten a soft cloth with water, wring it out well, and use it to wipe the surface  
of the disc from the center out. Wipe off any remaining moisture with a dry soft cloth.  
Never affix an adhesive label to a disc. This will affect the use of the disc and may result in an irreparable  
problem.  
4 of 5  
Ergonomic Considerations  
Your computer is a portable device that may be used in various environments. Whenever possible,  
consider the following ergonomic factors for both stationary and portable environments:  
Position of your computer – Placing the computer directly in front of you:  
1. Keep your forearms horizontal.  
2. Position your wrists in a neutral, comfortable position while using the keyboard, touch pad, or  
external mouse.  
3. Let your upper arms hang naturally at your sides.  
4. Take frequent breaks while using your computer.  
Excessive use of the computer may cause strain to your eyes, muscles, or tendons.  
Furniture and posture – Sit in a chair with good back support. Adjust the level of the chair so your feet  
are flat on the floor. A footrest may make you more comfortable. Sit in a relaxed, upright posture and  
avoid slouching forward or leaning far backwards.  
Viewing angle of the computer's display – Use the display's tilting feature to find the best position. You  
can reduce eye strain and muscle fatigue by adjusting the tilt of the display to the proper position. Adjust  
the brightness level of the display as well.  
Lighting – Choose a location where windows and lights do not cause glare and reflection on the display.  
Use indirect lighting to avoid bright spots on the display. Proper lighting adds to your comfort and work  
efficiency.  
Positioning an external display – When using an external display, set the display at a comfortable  
viewing distance. Make sure the display screen is at eye level or slightly lower when you are sitting in  
front of the monitor.  
5 of 5  

Philips Sjm3120 User Manual
Philips Ss951p User Manual
Sanyo N 550aas User Manual
Savin Ld238c User Manual
Toshiba E Studio 555 User Manual
Uniden Baby Monitor Ubr243 User Manual
Whirlpool Acc602xp0 User Manual
Xerox C2636 User Manual
Xerox Phaser 6110mfp User Manual
Zenoah Gt80 Twin User Manual