Supplied Accessories
Stereo Headphones (RFEV718P)• • • • • • • • • • 1
Arm Belt (RKHT0002) • • • • • • • • • • • • • • • • • • 1
Batteries • • • • • • • • • • • • • • • • • • • • • • • • • • • 4
Specifications
Frequency range: FM; 87.9–107.9 MHz
(0.2 MHz steps)
The serial number of this product can be found on the
back of the cassette compartment cover or inside the
battery compartment.
Please note it in the space provided below and keep
as a permanent record of your purchase to aid identi-
fication in the event of theft.
87.5–108.0 MHz
(0.1 MHz/0.05 MHz steps)
FM-AM 2 Band Receiver
Operating Instructions
Be sure to give the model number and color of the
unit when purchasing replacement headphones.
AM; 520–1710 kHz
(10 kHz steps)
MODEL NUMBER
SERIAL NUMBER
RF-SW50
522–1629 kHz
(9 kHz steps)
≥To order accessories contact 1-800-332-5368
Model No.
RF-SW50
Jack:
Output; HEADPHONES
or the website (http://www.panasonic.com).
Power requirement: Battery; DC 1.5 V
(R03/LR03, AAA, UM-4 battery)
≥Use numbers indicated in parentheses when
Dimensions :
68.1k97.8k25.2 mm
asking for replacement parts.
RF-SW50
(WkHkD)
(211⁄16qk37⁄8qk1q)
p
Mass:
74 g (2.6 oz.)
Panasonic Consumer Electronics Company,
Division of Matsushita Electric Corporation of
America
One Panasonic Way Secaucus, New Jersey 07094
(without battery)
Note:
Specifications are subject to change without notice.
Mass and dimensions are approximate.
Panasonic Sales Company, Division of
Matsushita Electric of Puerto Rico, Inc. (“PSC”)
Ave. 65 de Infantería, Km. 9.5 San Gabriel Industrial
Park, Carolina, Puerto Rico 00985
Play time:
CAUTION:
[When used in hold mode, at 25eC (77eF) and
on a flat and stable surface]
Alkaline dry
This device complies with Part 15 of the FCC
Rules. Operation is subject to the conditions that
this device does not cause harmful interference.
Any unauthorized changes or modifications to
this equipment would void the user’s authority to
operate this device.
c
2003 Matsushita Electric Industrial Co., Ltd.
Before connecting, operating or adjusting this
product, please read these instructions complete-
ly. Please keep this manual for future reference.
cell battery;
FM; About 25 hours
AM; About 26 hours
Printed in Taiwan.
RQTT0539-P
F0203TH0
≥The play time may be less depending on the
operating conditions.
P
CHANGING
THE TONE
BATTERY CONDITION
(When the radio is off)
XBS
ON
OFF
FULL
EMPTY
INSTALL A BATTERY.
Press in and down towards
the minus end.
3
4
ADJUST THE
VOLUME.
1
RELEASE HOLD.
-
+
One R03/LR03, AAA, UM-4
battery
VOL
HOLD
5
CONNECT THE HEADPHONES.
Plug in firmly.
L
R
2
SELECT THE BAND.
RF-SW50
SELECT THE STATION.
(UP)
3
Ë
“AM”
“FM”
(DOWN)
When a station is tuned in.
“OFF”
1
Plug type: 3.5 mm (1/8 in.) stereo
2
1
2
1
2
ª
To turn off
Press [≥AM/FM/OFF, %MODE
/
] during reception and select “OFF”.
Troubleshooting Guide
Arm Belt
Before requesting service, make the below checks. If you are in doubt about some of the check points, or if
the remedies indicated in the chart do not solve the problem,
contact the Panasonic Customer Call Center at 1-800-211-7262, or e-mail consumerproducts@pana-
sonic.com, or the website (http://www.panasonic.com).
To attach the arm belt
Rest the clip on the back of the unit so it
1 Put the belt on your
fits inside the guides, then slide it so it
clicks into place.
1
2
arm.
Clip
1
BEFORE CALLING
2 Adjust the strap with
2
the fabric fastener.
Guide (on the back of
the unit)
Fabric fastener
Ensure the clip is fixed firmly or it can fall off.
PROBLEM
CHECKPOINT
To detach the arm belt clip
Press both sides of the clip and push to slide out.
≥Is the battery worn?
≥Is the unit in the hold state?
≥Has the battery been installed with its polarities (+,-)
reversed?
No operations.
1
2
1
≥Is the headphones plug firmly connected to [Ë] jack?
≥Is the plug dirty?
≥No sounds.
≥A gritty noise is heard.
≥Cannot hear– too noisy.
≥Separate the unit from mobile phones.
|