Oreck Vacuum Cleaner TEK 100 User Manual

®
S I M P L Y A M A Z I N G  
Users GUide  
SPEED SWEEP  
Model Tek100  
•IMPORTANT•  
SAVE THIS BOOKLET!  
Includes:  
Important Safety Instructions  
Warranty  
Operating Instructions  
REGISTER YOUR PRODUCT  
ON THE WEB:  
WWW.ORECK.COM  
 
Safety Warning  
1. Be sure to use the product in compliance with the contents of this manual, and use  
approved Oreck replacement parts.  
2. After unpacking, make sure that the appliance is intact with no visible signs of damage  
caused during shipping. If damage has occurred, do not use this product. Take it to  
an authorized Oreck Clean Home Center for service. All packing materials (plastic  
wrapping, cardboard box, etc) are potentially dangerous and must be kept out of  
children’s reach.  
3. Do not leave this product unattended when power is on.  
4. Be sure to keep the air intake free and clear of any large debris which can cause a  
blockage in the air flow, impacting overall performance.  
5. Be sure to keep the air exhaust outlet free and clear to prevent the risk of the motor  
burning out.  
6. Do not use this product on uneven floors or surfaces and be careful when cleaning  
stairs to prevent this unit from falling down.  
7. Keep away from heat sources (such as central heating air vents, ovens, etc.) to prevent  
the distortion of plastic parts.  
8. Before using this product, please remove any large or sharp matters on the floor in  
order to avoid damaging internal parts including the filter and motor.  
9. Do not try to pick up wet or other liquid items, which will result in damage to the  
motor.  
10. Keep any loose clothing items away from moving brush roll.  
11. The charger is uniquely designed for the rechargeable Ni-MH battery, rating:  
Input: 120V, 60 Hz, 50mA  
Output: 9V DC, 280Ma  
Class:  
2
12. After inserting the plug of the charger into the electrical socket, the power light (green)  
will illuminate. Insert the rechargeable battery module, this will cause the charge  
indicator light (red) to blink. Battery will be fully charged after 8 hours when red light  
is solid (not blinking).  
13. Once the battery is fully charged, it can be placed into the unit. Before doing so, be  
sure to switch the power “OFF” to prevent any possible electrical charge.  
14. The brush roll should be cleaned on a regular basis in order to maintain optimal  
performance.  
15. The filter inside the dirt cup can simply be washed in warm soapy water and can be  
used again after drying.  
16. It’s suggested to change the filter every 6-12 months, however this may vary depending  
upon use.  
2
 
Warranty  
ORECK MANUFACTURING COMPANY: (ORECK gives you the following limited warranty  
for this product only if it was originally purchased for use, not resale, from ORECK or an  
ORECK Authorized Retail Dealer.)  
ORECK will repair or replace, free of charge, to the original purchaser, any part which  
is found to be defective in material or workmanship within one (1) year of the date of  
purchase.  
This limited warranty applies to normal domestic use. Any commercial use of this product  
will void this limited warranty.  
This limited warranty does not cover the replacement of expendable or consumable parts  
such as belts, brushes, bulbs, dirt filters, batteries and other parts subject to normal wear.  
This limited warranty does not apply to any part subjected to accident, abuse, commercial  
use, alteration, misuse, damage caused by fire or act of God, the use of voltages other than  
indicated on the serial number plate of this product or service of this product by other than  
ORECK or an ORECK Factory Authorized Service Center.  
ORECK does not authorize any person or representative to assume or grant any other  
warranty obligation with the sale of this product.  
ORECK’s limited warranty is valid only if you retain proof of purchase from ORECK or an  
ORECK Authorized Retail Dealer for this product. If you purchase this product from any  
other source, your purchase is “AS IS,” which means ORECK grants you no warranty, and  
that you, not ORECK, assume the entire risk of the quality and performance of this product,  
including the entire cost of any necessary servicing or repairs of any defects.  
ORECK’s liability for damages to you for any costs whatsoever arising out of this statement  
of limited warranty shall be limited to the amount paid for this product at the time of original  
purchase, and ORECK shall not be liable for any direct, indirect, consequential or incidental  
damages arising out of the use or inability to use this product.  
Some states do not allow the exclusion or limitation of incidental or consequential damages,  
so the above limitation or exclusion may not apply to you.  
ALL EXPRESS AND IMPLIED WARRANTIES FOR THIS PRODUCT, INCLUDING IMPLIED  
WARRANTIES OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE,  
ARE LIMITED IN DURATION TO THE WARRANTY PERIOD, AND NO WARRANTIES,  
WHETHER EXPRESS OR IMPLIED, WILL APPLY AFTER THIS PERIOD.  
Some states do not allow limitations on the duration of implied warranties, so the above  
limitation may not apply to you. This warranty gives you specific legal rights, and you may  
also have other rights which vary from state to state.  
3
 
Parts & Accessories List  
1. Handle  
2. Upholstery brush  
3. Crevice tool  
1
4. Accessory hook  
5. Handle button  
2
6. Battery release button  
7. Battery compartment  
8. Power button  
2
3
4
9. Carry handle  
10. Dirt Cup  
5
11. Roller brush release button  
12. Roller brush  
7
8
13. Dirt cup release button  
6
9
10  
11  
13  
12  
4
 
Assembly Instructions  
Before assembling, please be sure that all parts and accessories are  
included by reviewing the Parts and Accessories List.  
Dirt Cup Assembly  
As is shown in the Figure below, place the toll bar of the dust barrel on the back  
of the unit, and press down the dirt cup. When the front-end hook on the dirt cup  
is placed into the corresponding part on the unit completely, press firmly until a  
“click” is heard confirming it is securely in place. To remove the dirt cup, simply  
grasp the bottom end of the dirt cup and press the release button, while pulling  
away from the unit.  
DIrT CUP rELEASE BUTTOn  
Emptying the Dirt Cup  
After removing the dirt cup as described above, you can now empty its contents.  
HAnDLE Of DIrT CUP fILTEr  
5
 
Assembly Instructions  
Assembly of roller Brush  
As is shown in the figure below, carefully insert the roller brush into the unit, making  
sure to align within the specific guide slots and ensuring electric contacts are fully  
aligned.  
ELECTrICAL COnTACTS  
GUIDE SLOTS  
Assembly of the Handle  
As shown below, pressing the handle release button will allow for the handle to be  
removed from the main unit. To reinstall, simply reinsert the handle making sure  
the guide slots line up.  
HAnDLE rELEASE BUTTOn  
6
 
Assembly Instructions  
Operation  
1. It is necessary for the rechargeable battery to be fully charged prior to use.  
2. The charger is uniquely designed for the rechargeable Ni-MH battery, rating:  
Input: 120V, 60 Hz, 50mA; Output: 9V DC, 280Ma; Class: 2  
3. After inserting the plug of the charger into the electrical socket, the power light  
(green) will illuminate. Insert the rechargeable battery module, this will cause  
the charge indicator light (red) to blink. Battery will be fully charged after  
8 hours when red light is solid (not blinking).  
4. Once the battery is fully charged, it can be placed into the unit. Before doing  
so, be sure to switch the power “OFF” to prevent any possible electrical  
discharge.  
BATTEry  
BATTEry  
CHArGEr  
Battery removal  
Removing the rechargeable battery is done by simply pressing the battery release  
button located on the side of the unit as shown below.  
BATTEry rELEASE BUTTOn  
7
 
Assembly Instructions  
Accessory Items  
Included with this unit are two accessory items: a crevice tool and upholstery  
brush.  
A) Crevice Tool  
Shown below, the crevice tool is attached for cleaning in tight spaces.  
B) Upholstery Brush  
With the crevice tool still attached, affix the upholstery brush to the end of the  
crevice tool as indicated below.  
8
 
Maintenance  
1. Dirt Cup filter  
After emptying the dirt cup as described above, the filter can also be cleaned  
at the same time. By grasping the filter screen guard in one hand, use the  
opposite hand to rotate the handle as indicated by the arrow direction shown  
on the top of the filter. Once removed, the filter can be shaken off to remove  
any collected debris.  
fILTEr SCrEEn GUArD  
2. Air intake screen  
As shown below, the air intake screen can be removed and cleaned in warm  
soapy water. Once completely dry, it can be placed back into the unit.  
AIr InTAKE SCrEEn  
9
 
Troubleshooting  
Problem  
Cause  
Areas to check  
The unit does not work 1. The battery has been  
1. Insert the battery  
2. Charge the battery  
or turn on.  
inserted incorrectly  
2. The battery has not  
been charged  
roller brush is not  
working  
1. Roller brush has  
debris wrapped  
around it.  
1. Remove the roller  
brush and thoroughly  
clean, then reinsert  
back into the unit.  
The indicator lamp  
(red) does not work  
when charging  
1. The power cord is not 1. Be sure the power  
plugged in.  
cord is plugged into  
the electrical outlet  
2. The battery has not  
been securely inserted 2. Secure the battery is  
into the charger.  
correctly inserted into  
the charger.  
10  
 
Discarding the Vacuum  
Remove the batteries by cutting the connector wires one by one before you discard the  
appliance. Do not dispose of batteries with your regular household trash. Dispose of them  
in an environmentally safe manner.  
Battery Disposal  
Remove the batteries by cutting the connector wires one by one before you discard the  
appliance. Do not dispose of batteries with your regular household trash. Dispose of them  
in an environmentally safe manner.  
To preserve natural resources,  
please recycle or dispose of  
expired battery pack properly.  
THIS PRODUCT CONTAINS A NICKEL-METAL HYDRIDE  
BATTERY.ITMUSTBEDISPOSEDOFPROPERLY.LOCAL,  
STATE, OR FEDERAL LAWS MAY PROHIBIT DISPOSAL  
OF NICKEL-METAL HYDRIDE BATTERIES IN ORDINARY  
TRASH. CONSULT YOUR LOCAL WASTE AUTHORITY  
FOR  
INFORMATION  
REGARDING  
AVAILABLE  
RECYCLING AND/OR DISPOSAL OPTIONS. FOR  
DISPOSAL INFORMATION, CALL THE RECHARGEABLE  
BATTERY RECYCLING CORPORATION AT 1-800-8-  
BATTERY.  
WARNING:  
Upon removal, cover the battery pack’s terminals with  
heavy duty adhesive tape. Do not attempt to destroy or  
disassemble battery pack or remove any of its components.  
Nickel-metal hydride batteries must be recycled or disposed  
of properly. Also, never touch both terminals with metal  
objects and/or body parts as short circuit may result. Keep  
away from children. Failure to comply with these warnings  
could result in fire and/or serious injury.  
©2009 Oreck Holdings, LLC. All rights reserved. All word marks, logos, product configurations, and registered trademarks are owned and used  
under the authority of Oreck Holdings, LLC. Printed in America  
75851-01 REV A  
8/09 ECN# R-9480  
 

Miele Oven H 5981 BP User Manual
Miele Washer 05 960 780 User Manual
Network Technologies Switch KEEMUX Px User Manual
Numark Industries Turntable TT 1520 User Manual
Olympus Headphones SCPH 10130U User Manual
One for All Universal Remote URC 7781 User Manual
Onkyo CD Player DX 7355 User Manual
Oricom Marine Radio UHF100 User Manual
Panasonic Digital Camera AJ SDC915 User Manual
Parker Products Network Card OEM650 User Manual