Oki Network Card 310Eplus User Manual

OKILAN 310e+ Installation Guide  
Warning: Disconnect the printer from a.c.  
power before installing board.  
Insert the OKILAN 310e+ into the  
printer making sure that the board  
locates in the guide rails. Push the  
board firmly into place. Tighten the  
screws (if fitted) on the option  
board. If the screws do not locate,  
the board may not be properly  
seated.  
1
2
4
Turn the printer around so that the rear is facing you.  
After you have installed the Network Print Server:  
Confirm that your printer recognizes the new components, including  
any additional RAM memory, by printing the menu. Refer to your  
printer's User's Guide for this procedure. Refer to your OKILAN 310e+  
Network Administrator's Guide for additional information regarding  
configuring and cabling details.  
5
Use a screwdriver to remove serial interface board from back panel  
of printer.  
If a SIMM module is present on the serial interface board, you will  
need to migrate it to the SIMM 1 slot on the OKILAN 310e+ card  
(see Installing SIMM Options, step 1, below).  
Installing SIMM Options  
1
Use SIMM 1 slot for additional  
memory only.  
Use SIMM 2 for FLASH ROM option only.  
Insert the gold metallic  
contact edge of the  
3
2
SIMM firmly into the  
socket at a 30 degree  
angle. Bring the SIMM  
upright to a 90 degree  
angle until the SIMM  
clicks into place.  
Locate guide rails and edge connector .  
2000 Bishops Gate Blvd. Mt. Laurel, NJ 08054 1-800-OKIDATA (800-654-3282)  
Fax: 856-222-5247 http://www.okidata.com  
© 1999 Okidata  
 

Miele Microwave Oven H 5360 B User Manual
Milwaukee Camera Accessories 2311 21 User Manual
Milwaukee Cordless Drill 2402 20 User Manual
Multiquip Water Pump QP2E User Manual
Nexgrill Gas Grill 720 0001 R User Manual
Nokia Headphones HDW 3 User Manual
NordicTrack Home Gym NTC89021 User Manual
Oki Printer 59318401 User Manual
Onkyo MP3 Docking Station 29344880A User Manual
Oreck Vacuum Cleaner XL2070RHSM User Manual