Part No. 208290-B
April 2000
4401 Great America Parkway
Santa Clara, CA 95054
Installing the
Passport 8006
Chassis Fan Tray
About This Guide
This guide provides instructions for replacing a fan tray in the Passport™ 8006 Chassis. For more
information about the chassis, refer to Installing the Passport 8006 Chassis (part number 207313-B).
You can replace a fan tray without turning off power to the chassis. To maintain proper cooling of the
chassis, be sure to install the replacement fan immediately.
Replacing a Fan Tray
Required tool: Phillips screwdriver
9590FA
1. Loosen the retaining screws and pull the fan tray out of the chassis until the power connector
disconnects from the backplane.
Wait 10 seconds for the fans to stop turning, and then pull the tray out of the chassis.
Caution: Grasp the fan tray at the middle of the front panel, and be careful to keep your
fingers out of the fan blades.
1
9591FA
9592FA
3. When the chassis power is on, verify that the
green status LED is lit.
2. Slide the new fan tray into the chassis and
tighten the retaining screws.
2
|