Contents
Introduction
Installing the AF-10
Using the AF-10
Loading Documents Manually
Troubleshooting
Specifications
Paper Limitations
Auto Document Feeder
AF-10
User’s Manual
- 1 -
Introduction
Installing the AF-10
Thank you for purchasing the Nikon Auto Document Feeder
AF-10 for the full-color flatbed scanner ScanTouch 110.
This manual describes the procedure for setting up the AF-10
and connecting it to the ScanTouch 110. Please read this
manual thoroughly to ensure proper installation and operation
of the unit.
1. Turn off your scanner and unplug its power cord from the
AC power outlet.
2. Remove the document cover from the scanner.
For practical procedures on how to scan and reproduce images
using the ScanTouch 110 with the Automatic Document
Feeder AF-10, please refer to the software manual.
We hope that you find this manual helpful.
Document cover
Accessories
The following items are included with your Auto Document
Feeder AF-10. On opening the package, if any items are
missing, please contact your dealer immediately.
• Auto Document Feeder AF-10 (1)
• Open Me First envelope (1)
• User’s Manual (1)
- 3 -
3. Fit the two holes in the hinge plate of the AF-10 over the
small supporting posts on the scanner.
7. Plug in the scanner’s power cord and turn the power switch
on.
4. Gently slide the AF-10 so that the supporting posts move
into the narrow sections of the holes.
Note: When you remove the AF-10, store the two lockdown
screws in the holes on the back of the unit, until they are needed
again.
5. Attach the AF-10 with the two lockdown screws provided.
Insert screws into the center of each hinge bracket and use a
coin to tighten the screws securely.
6. Connect the AF-10 interface cable to the connector on the
rear panel of the scanner.
- 4 -
3. Slide the paper guides on the upper tray towards each other,
until they just contact the edges of the document stack.
Using theAF-10
Begin by removing any document from the document setting
glass of the scanner, and then make sure that the AF-10 is
closed.
1. Turn the scanner on.
2. Place the documents in the upper tray, face up, as shown.
4. After aligning the document stack, insert the documents until
you can feel them contact the document-stopper of the
AF-10.
The AF-10 can be loaded with up to 50 sheets (a stack
thickness of 6 mm or less) of the following paper sizes:
Check size 3 x 5 inches
(76mm x 127mm)
A5
B5
A4
5.8 x 8.3 inches (148.5mm x 210mm)
7.2 x 10.1 inches (182mm x 257mm)
8.3 x 11.7 inches (210mm x 297mm)
Letter
Legal
8.5 x 11 inches
8.5 x 14 inches
(216mm x 279mm)
(216mm x 356mm)
- 5 -
Loading Documents Manually
You can still load documents manually, even with the AF-10
installed.
1. Open the front end of the AF-10.
2. Place the document on the document setting glass of the
scanner, then lower the AF-10 and initiate the scan.
- 6 -
(Condition 2)
Troubleshooting
If the jammed paper has not yet arrived at the exit of the
AF-10, slowly pull the jammed paper backward until it is fully
released.
Removing a Jammed Document
1. Raise the cover of the AF-10.
3. After removal of the jammed document, gently close the
cover of the AF-10.
2. (Condition 1)
If the jammed paper is at the exit of the AF-10, lift the upper
tray, and slowly pull the jammed paper toward you until it is
fully released from the feeder mechanism.
- 7 -
3. Insert the transparency edge of the new Transparent Sheet
between the paper guide (A or B) of the AF-10, with the
white sheet to the lower side.
Replacing theTransparent Sheet
The quality of your scans may degrade overtime. Quite often
this is caused by a scratched or dirty Transparent Sheet. You
can contact your dealer to purchase a replacement. To replace
a worn Transparent Sheet, follow these steps:
4. Insert the two hooks of the Transparent Sheet into the
AF-10.
5. Push down the two protrusions of the Transparent Sheet as
far as they will go.
1. Raise the cover of the AF-10.
2. Remove the Transparent Sheet from the AF-10 by pulling
the two hooks of the Transparent Sheet toward you, and
pushing it up.
6. Gently close the cover of the AF-10.
- 8 -
Specifications
Paper Limitations
Size:
Weight:
10.0 lbs (4.5kg)
Width:
Length:
3.0 to 8.5 inches (76 to 216mm)
5.0 to 14 inches (127 to 356mm)
Dimensions: 12.7 (W) x 20.6 (D) x 4.1 (H) inches
(322 x 524 x 104mm)
Thickness:
Weight:
0.065 to 0.145 mm
Paper capacity: 6mm document stack (50 pages for 0.1t
paper)
50 to 127 g/mm
Operating Environment:
Paper Quality:
Temperature:
Humidity: 20 to 85% R.H. (no condensation)
41°F to 95°F (5°C to 35°C)
Copy Paper
Document Condition:
Use with ink that will not be transferred to the
Storage Environment:
Temperature:
Humidity: under 95% R.H. (no condensation)
–4°F to 140°F (–20°C to 60°C)
rollers. Torn, holed, wrinkled, or folded paper,
paper with adhesive tape, carbon, or paper
clips attached, or paper with wet ink, can cause
a paper jam or damage to the AF-10.
- 9 -
EC DECLARATION OF CONFORMITY
ERKLÄRUNG ÜBER EG-NORMENGERECHTHEIT
We
Wir
Name:
Nikon UK Limited
Name:
Nikon UK Limited
Address:
Nikon House, 380 Richmond Road, Kingston,
Surrey KT2 5PR, UK
Anschrift:
Nikon House, 380 Richmond Road, Kingston,
Surrey KT2 5PR, UK
declare that the product
Product Name:
Manufacturer’s Name:
Manufacturer’s Address:
erklären hiermit, daß das folgende Produkt
Produktbezeichnung:
Name des Herstellers:
Anschrift des Herstellers: Fuji Bldg., 2-3, Marunouchi 3-chome, Chiyoda-
ku, Tokyo 100, Japan
den nachstehend aufgeführten Normen genügt:
EN55022 Klasse B
Auto Document Feeder AF-10
Nikon Corporation
Fuji Bldg., 2-3, Marunouchi 3-chome, Chiyoda-
ku, Tokyo 100, Japan
Automatischer Vorlageneinzug AF-10
Nikon Corporation
is in conformity with the following Standards
EN55022 Class B
EN50082-1
EN50082-1
IEC801-2: 1984 8kV
IEC801-2: 1984 8kV
IEC801-3: 1984 3V/m
IEC801-3: 1984 3V/m
IEC801-4: 1988 1kVAC, 0.5kV, I/O
IEC801-4: 1988 1kVAC, 0.5kV, I/O
und zwar gemäß den Bestimmungen der EMC-Richtlinie (89/336/EEC)
following the provisions of the EMC Directive (89/336/EEC)
DECLARACIÓN DE CONFORMIDAD DE LA CEE
DECLARATION DE CONFORMITE DE LA CEE
Nous
Nosotros
Nom:
Nikon UK Limited
Nombre:
Nikon UK Limitada
Address:
Nikon House, 380 Richmond Road, Kingston,
Surrey KT2 5PR, UK
Dirección:
Nikon House, 380 Richmond Road, Kingston,
Surrey KT2 5PR, UK
déclarons que ce produit
Nom du produit:
Nom du fabricant:
Adresse du fabricant:
declaramos que este producto
Chargeur Feuille à Feuille AF-10
Nikon Corporation
Fuji Bldg., 2-3, Marunouchi 3-chome, Chiyoda-
ku, Tokyo 100, Japan
Nombre del producto:
Nombre del fabricante:
Dirección del fabricante:
Alimentador automático de documentos AF-10
Nikon Corporation
Fuji Bldg.,2-3, Marunouchi 3-chome, Chiyoda-ku,
Tokyo 100, Japón
est conforme aux normes suivantes
EN55022 Classe B
EN50082-1
es conforme a las normas siguientes
EN55022 Clase B
EN50082-1
IEC801-2: 1984 8kV
IEC801-2: 1984 8kV
IEC801-3: 1984 3V/m
IEC801-3: 1984 3V/m
IEC801-4: 1988 1kVAC, 0.5kV, I/O
IEC801-4: 1988 1kVCA,0,5kV E/S
selon les dispositions de la directive de la CEE (89/336/EEC)
según las disposiciones de la directiva de la CEE (89/336/EEC)
Kingston, UK
Place
March 1, 1996
Date
Signature/Managing Director
Signature/Directeur général
Unterschrift/Geschäftsführer
Firma/Director general
Lieu
Date
Ort
Lugar
Datum
Fecha
- 10 -
|