New Holland
Forage Blower Specifications
F62B
MODEL
LENGTH
WIDTH
F62B
108 in. (2,743 mm)
100 in. (2,540 mm)
1,605 lbs. (729 kg)
WEIGHT
BLOWER
Blowing height*
Blower housing
Paddles (adjustable)
Paddle tip speed
Drive
Over 100 ft. (Over 30 m)
60 in. dia. (1,524 mm)
8
8,460 ft./min. (2,579 m/min.)
Direct PTO
HOPPER
Diameter
Auger–12 in. (305 mm)
Auger–50 in. (1,270 mm)
Length
Width
Height from ground
37 in. (940 mm)
1
2
Adjustable–20 ⁄ in. (520 mm)
1
8
to 27 ⁄ in. (699 mm)
Feeder type
Auger
DRIVELINE PROTECTION
Shearbolt
PTO
540 rpm
TIRES
4.80–8 “C” load range
CAPACITY (with adequate power)
Corn silage*
Haylage*
Up to 180 tons/hr. (163 mt/hr.)
Up to 110 tons/hr. (100 mt/hr.)
OPTIONAL EQUIPMENT
Pipe Clamp
Kwik Pipe Bundle
Telescoping Pipe Section
Hinged Deflector
Safety Tow Chain+
* Capacity and height will depend upon tractor horsepower, type of crop, moisture content, length of cut, as well as general maintenance of pipes and spout.
+ Available from New Holland Service Parts.
Design, materials and/or specifications are subject to
change without notice and without liability therefor.
Specifications are applicable to units sold in Canada, the
United States, its territories and possessions, and may
vary outside these areas.
Safety begins with a thorough understanding of
the equipment. Always make sure you and
your operators read the Operator’s Manual
before using the equipment. Pay close
attention to all safety and operating
decals and never operate machinery
without all shields, protective devices
and structures in place.
© 2008 CNH America LLC
New Holland is a registered trademark of CNH America LLC.
Page 1of 1
|