SCXI-1371 RACK-MOUNT KIT
This guide describes how to attach the SCXI-1371 rack-mount kit to an
SCXI-1000, SCXI-1000DC, or SCXI-2000 chassis.
Introduction
You can use the SCXI-1371 rack-mount kit to mount an SCXI-1000,
SCXI-1000DC, or an SCXI-2000 chassis in a standard 19 in. rack. With
the multiposition rack-mount brackets, you can install the SCXI chassis
in one of six different positions to attain the desired front panel depth.
What You Need to Get Started
❑ SCXI-1371 rack-mount kit
Rack-mount bracket
Four 8-32 by 5/16 in. Phillips flathead screws
Four 10-32 by 1/2 in. Phillips panhead screws
Rack-mount bracket for the 4-slot SCXI-1371 chassis (with the
longer side panel)
Brace for the 4-slot SCXI-1371 chassis
Four 6-32 hex nuts
Four no. 6 lockwashers
Two 6-32 by 1/4 in. Phillips panhead screws
SCXI-1371 Rack-Mount Kit Installation Guide
❑ No. 2 Phillips-head screwdriver
❑ 5/16 in. nut driver
❑ SCXI chassis
SCXI ™ is a trademark of National Instruments Corporation. Product and company names are trademarks or trade names of their respective
companies.
371195A-01
© Copyright 1994, 1997 National Instruments Corp. All rights reserved.
August 1997
1. Turn off the SCXI-1000, SCXI 1000DC, or SCXI-2000 chassis
power.
2. Use the 6-32 hex nuts (item 7) and no. 6 lockwashers (item 5) to
attach the brace (item 6) to the rack-mount bracket with the longer
side panel (item 1).
3. Using the four 8-32 screws (item 2), attach the rack-mount brackets
(items 1 and 4) to your SCXI chassis.
4. Use the two 6-32 screws (item 3) to secure the rack-mount brackets
(items 1 and 4) to your SCXI chassis when they are in positions 1, 2,
3, or 4. Figure 2 shows the completed assembly.
5. Use the four 10-32 screws shown in Figure 2 to attach the assembly
to your rack.
10-32 Screws
SCXI Chassis
Figure 2. Attaching the Assembly to Your Rack
3
|