409-00072-000 6/7/00 11:30 AM Page 1
®
PowerMate ES Series System Board Configuration
Jumper Settings
JP2
JP2
USB
Keyboard
Wakeup
Factory setting.
Disables system
wakeup by USB
keyboard.
Enables system
wakeup by USB
keyboard.
3
2
1
3
2
1
Note: See your PowerMate ES Series User’s Guide
for detailed option installation information.
JP1
Keyboard
at
Power On
Factory setting.
Disables keyboard at power on.
Memory Upgrade
■ Maximum memory supported: 512 MB;
minimum memory required: 32 MB.
1
1
2
3
3
JP1
Enables keyboard
at power on.
■ Memory type and size can vary between sockets.
2
■ System supports 168-pin, 100-MHz non-ECC SDRAM modules
in 32-MB, 64-MB, 128-MB, and 256-MB configurations.
Use NEC memory upgrade kits for the best compatibility with your
system. For memory compatibility information, call Technical Support.
JP3
JP3
Save to
RAM
Factory setting.
Enables Suspend
mode Save to RAM
(STR) function.
Disables Save
to RAM function.
■ Single- or double-sided DIMMS are supported.
■ No jumper setting required.
JP13
2
JP13
USB Port
Selection
Factory setting.
Disables front
USB port and
enables rear
USB port.
3
6
1
3
2
1
Enables front
USB port and
rear USB port.
Processor Upgrade
See your user’s guide for detailed processor upgrade information.
5
4
6
5
4
JP2
Processor Socket 370
JP19
PCI Slots
Jumper
CMOS
Clear
Factory setting. Maintains system board
configuration in CMOS RAM with onboard
battery.
1
2
3
JP1
Jumper
JP19
Clears CMOS while system power is off.
Return jumper to pins 2 and 3 before
powering system on.
1
2
3
Caution: To prevent damage to the system board,
avoid clearing CMOS while power is on.
JP15
System
Memory
Upgrade
Sockets
BIOS
Recovery
Factory setting. Sets the system for
normal operation. The BIOS uses current
configuration information and passwords
at power on.
1
2
3
To enable BIOS recovery for a corrupted
system, remove the jumper. Wait 10 seconds.
Replace the jumper on pins 1 and 2.
JP15
JP13
Jumper
Primary
IDE Connector
JP3
Restores Safe BIOS settings as the
default BIOS settings and loads the
BIOS Setup at power on.
Jumper
1
2
3
Secondary
IDE Connector
JP15
Jumper
JP19
Jumper
Technical Support: 800-632-4525
409-00072-000
|